Page 1 of 1

Potentiometer range problem in passthru mode

Posted: Mon Aug 15, 2016 5:14 pm
by dufflespank
Hi There, I just got myself a brand new P12, and so far it has been great. I'm having one issue though... I've set the pot mode to passthru, but sometimes, if a parameter is set to the extreme (0 or 127), I can't pick it up by turning the pot. The only way to change the parameters is to use the soft knobs to bring the value away from the extreme, at which point I can then use the pot to edit it. I was hoping there was some sort of pot calibration routine but I'm not seeing one, am I missing something?