Arp | Volume issue

The Dave Smith Instruments Prophet-12 Analogue Synthesizer

Moderator: Pym

Post Reply
Anti-Bad
Posts: 4
Joined: Wed Oct 21, 2015 5:58 am

Arp | Volume issue

Post by Anti-Bad » Fri Jul 29, 2016 2:38 pm

Hi,

this isn't an issue so much affecting my work flow
more something I can't figure out.

Issue: I loop a region in Logic, test out an arp line to record
but if it's too loud I turn down the Prophet volume.
As soon as the loop returns to the start of the region the volume jumps
back up. Only happens when using the arpeggiator.

I'm a bit rusty, I understand the envelope adsr retriggering
but thought that's just the timbre shape. Why would having
set the volume lower it jump back up when the loop restarts.

I can work around it but I can't figure this out.

Thanks for reading & any help

HasseFX
Posts: 20
Joined: Sun Jan 18, 2015 11:04 am

Re: Arp | Volume issue

Post by HasseFX » Sun Jul 31, 2016 3:05 am

Did you happen to record the volume change into the region in Logic? Check for any CC#7 in the controller editor or the list.

Post Reply